Hazyjack NEIPA

METHOD:

Mill the grains and dough-in targeting a mash of around 3 Litres of water to 1 Kg of grain (a liquor-to-grist ratio of about 3:1 by weight) and a temperature of 67 °C (152 °F). Approx. 17L of water at strike temp of 73C (more if you have a false bottom single vessel brewery).
Hold the mash at 67 °C ( 152 °F ) until enzymatic conversion is complete.
Add first wort hop addition of 20 g Amarillo [8.6 %] post mash for 20 mins and 11 IBUs while you start sparging and/or ramping up for your boil
Infuse the mash with near boiling water while stirring or with a recirculating mash system raise the temperature to mash out at 76 °C (168 °F). Mash out for 10 minutes.
Fly sparge slowly with approx. 15 Litres of 76 °C water, collecting wort until the pre-boil kettle volume is around 25 L (6.6 gallons) allowing for a boil off of 2L/hour
The total boil time will be 60 minutes. Do not add Deltafloc or Irish Moss.
At flameout, wait until wort cools to 82°C (180 °F ) to avoid volatizing hop oils. Set time for 40 mins and add first hop stand addition (20g of Amarillo and 30g each for the LupoMax hops).
After 20 mins add the second hop stand additions (20g of Amarillo and 30g each for the LupoMax hops).
After the total hop stand of 40 minutes, chill wort to 19°C (67 °F ), decant starter or open Gold Pitch and pitch Yeast and aerate.
Over the course of the two-week fermentation, ramp the temperature up to 23°C (73 °F ) to ensure full attenuation.
On approximately Day 4 of fermentation when attenuation has reached about 80 percent, add the first dry hop addition for 3 days.
Wait 3 days, then remove the first dry hop addition and add the second addition of dry hops and dry hop for another 3 days.
When finished, carbonate the beer to approximately 2.5 volumes (5 g/L) of CO2 (or add 125g of table sugar or 180g of Light Dried Malt Extract if bottling) and drink fresh. Prost!