- Joined
 - Jun 23, 2022
 
- Messages
 - 167
 
- Reaction score
 - 378
 
- Points
 - 63
 
Pardon me if there's already a thread for this, but after this morning, there needed to be. 

I've been fermenting, carbing, and serving from the same keg using a spunding valve for a year. I'm doing a NEIPA, and decided to transfer from the fermenting keg to a purged serving keg for the first time. Had a keg filled with Star San water, and set up to transfer to another keg. Attached my spunding valve to the receiving keg, and couldn't get a psi reading to save my life. I burped the keg, which did have gas in it. Eventually, I unhooked the jumper line, and discovered it actually was transferring. After 45 minutes of fussing and cussing, I finally realized I'd inserted the blow off tube into the wrong i/o on my spunding valve. No wonder it wasn't registering. Stupid, Stupid me.
 Luckily, I won't be transferring the actual beer for a few days. That's at least one mistake I won't be making again.
				
			I've been fermenting, carbing, and serving from the same keg using a spunding valve for a year. I'm doing a NEIPA, and decided to transfer from the fermenting keg to a purged serving keg for the first time. Had a keg filled with Star San water, and set up to transfer to another keg. Attached my spunding valve to the receiving keg, and couldn't get a psi reading to save my life. I burped the keg, which did have gas in it. Eventually, I unhooked the jumper line, and discovered it actually was transferring. After 45 minutes of fussing and cussing, I finally realized I'd inserted the blow off tube into the wrong i/o on my spunding valve. No wonder it wasn't registering. Stupid, Stupid me.
			
				Last edited: 
			
		
	
								
								
									
	
								
							
							
        
                
				

