Mash calculations in Brew steps

Discussion in 'Beginners Brewing Forum' started by bishop916, Jun 27, 2020.

  1. bishop916

    bishop916 New Member

    Joined:
    Jul 11, 2012
    Messages:
    7
    Likes Received:
    10
    Trophy Points:
    3
    Location:
    Rio Linda CA
    When going thru the brew steps the mash section includes 'mash at 151*', and 'add sparge at 178*' - however it doesn't show the appropriate temp of the strike water.

    After some digging around I found that I can go to the mash calculator section and get the information there, - is there any way to have the required strike water temp show in the brew steps?
     
    thunderwagn and Pricelessbrewing like this.
  2. Pricelessbrewing

    Pricelessbrewing QA Software Tester
    Staff Member

    Joined:
    Jun 8, 2016
    Messages:
    766
    Likes Received:
    503
    Trophy Points:
    93
    Gender:
    Male
    Hi Bishop, at this time that information is not in the brew steps. However it is definitely something that should be! We have a project in the works to simplify and unify all of the mash and volume information so you can use whichever resource you want.

    Right now I recommend using the brew sessions "mash calculator" tab. Until we get everything updated.

    upload_2020-6-27_9-16-21.png
     
    Yooper likes this.
  3. bishop916

    bishop916 New Member

    Joined:
    Jul 11, 2012
    Messages:
    7
    Likes Received:
    10
    Trophy Points:
    3
    Location:
    Rio Linda CA
    Thanks for the quick reply and support. Great work!

    - b916
     
    Yooper and Pricelessbrewing like this.
  4. Hawkbox

    Hawkbox Well-Known Member

    Joined:
    Jul 27, 2017
    Messages:
    3,746
    Likes Received:
    2,981
    Trophy Points:
    113
    Gender:
    Male
    Occupation:
    IT Manager
    Location:
    Edmonton
    Yeah it's a bit weird to not have it there but the calculator works pretty well.
     

Share This Page

arrow_white