What am I missing here or am I mis-entering my data? It looks like another new feature was added to enter not only the total Mash Volume but also the Strike water Volume. As you can see below, if I enter my 4.25 gal strike volume and 10.5 gal total mash volume, I end up with 44.7% conversion. Seems extremely low and unrealistic. When I only enter the 10.5 gal total mash volume, I end up with 110.4%. Also not completely accurate, but a lot closer to the 100% target.
This is an all-grain recipe for a simple IPA, 4.25 gal mash at 152F, and then 6.25 gal batch sparge at 168F for a 10.5 gallon total mash.
Thanks, Eric
This is an all-grain recipe for a simple IPA, 4.25 gal mash at 152F, and then 6.25 gal batch sparge at 168F for a 10.5 gallon total mash.
Thanks, Eric