- Joined
- May 15, 2020
- Messages
- 19
- Reaction score
- 10
- Points
- 3
Hi Beer People
I recently bought a unit to help me maintain the correct temp of my fermentation bucket.
Just a basic one with a probe on a wire that you then connect to the power supply of your heat mat.
But i found that with the probe wire going in to the fermenter i was not able to achieve an airtight seal, the bucket lid would not seal.
How do other people get around this problem?
Thanks in advance
I recently bought a unit to help me maintain the correct temp of my fermentation bucket.
Just a basic one with a probe on a wire that you then connect to the power supply of your heat mat.
But i found that with the probe wire going in to the fermenter i was not able to achieve an airtight seal, the bucket lid would not seal.
How do other people get around this problem?
Thanks in advance