Tilt Recalibration

Sanctuary Brewing

Active Member
Trial Member
Established Member
Joined
Apr 11, 2023
Messages
85
Reaction score
133
Points
33
I've heard the Tilts were difficult after replacing the battery and yes it's true. Fortunately I'm using the TiltPI and it allows for multiple calibration points.
Tools used, TiltPI, EasyDens, Water, Sugar, Water Pitcher

Grab a pitcher large enough for the Tilt to float without bumping the sides and fill it with 8 qts of water.
Float your tilt and enter the TiltPI Calibration Menu and delete all prior SG readings. Replacing the battery should not affect the temperature calibration.
Click Calibrate in water. This will create the first calibration point.
Stir in 8tbsp sugar, really well and take a gravity reading. You should be close to 1.020. I was at 1.021
Click Calibrate in known SG and enter the values, paying close attention to what the pre-calibration reading.
Stir in 7-8tbsp sugar, really well and take a gravity reading. You should be close to 1.040.
Click Calibrate in known SG and enter the values, paying close attention to what the pre-calibration reading.
Repeat the process up to 1.080 or even higher if you like. Pin this if you like.

1794333032667.png
1794333310400.png
 
Last edited:
Official recommendations and compatible options

Tilt (Baron Brew Equipment) specifically recommends:

• Streamlight CR123A
• Energizer CR123A (they also sell an Energizer version directly)
• Panasonic CR123A
• Other brands that match the approximate 16.1–16.5 g weight range

These are lithium manganese dioxide (Li-MnO₂) primary cells. The exact weight matters because the Tilt’s calibration and buoyancy depend on it. A battery that is even 1–2 g heavier can throw off the gravity reading enough that the device may not auto-calibrate properly in water or may behave as if it is too heavy and go to sleep.

Batteries to avoid
• Duracell CR123A — Consistently called out as too heavy (often an extra gram or more). Official videos and support notes repeatedly say “DO NOT use Duracell” because the added weight prevents correct calibration.
• Most generic/no-name CR123A batteries — Many cheap packs run heavier (examples around 17.9 g have been reported and confirmed by Tilt support as problematic).
• Rechargeable batteries (standard Li-ion or most others) — Voltage is too high and will damage the electronics. The only partial exception sometimes noted in older documentation is certain LiFePO₄ rechargeables, but even those are lighter and require multi-point calibration; current official guidance is that rechargeables are not compatible and can damage the unit.
 
Add me to the list, I recalibrated and I think it was close, but TBH, it was a chore and I'd always see the "corrections" applied and it would always make me uneasy.
 
I used Energizer.

That all being said, I really do not worry about the calibration: I just need to see the rate if gravity change - the actual value is unimportant to me.
 
I used Energizer.

That all being said, I really do not worry about the calibration: I just need to see the rate if gravity change - the actual value is unimportant to me.
Same boat as me. It's close enough, the trending for fermentation finish is more what I use it for.

That said, put in 3 or 4 cal points and it is within 2-3 pts
 

Back
Top