Robobrew died

Joined
Jun 25, 2019
Messages
9
Reaction score
3
Points
3
Hey Folks,
Has anyone had to repair their Robobrew Gen3? I have replaced the Circuit board and the control screen and all I get is a error code?

Any help would be great
 
There are all kinds of YouTube videos on different issues and fixes, you may find some help there. You could also contact Kegland by emailing them, the address is on their site, and they are very responsive.
Hope this helps
 
Good luck. My wife likes to tell me I'm wired the wrong way .. I hope that's not what you're getting here.
 
upload_2021-4-14_14-28-50.png So checked the wiring and may have just been one wire in the wrong place, but am going to replace the thermo circuit just to make sure and if that doesn’t work guess I’ll have to bite the bullet and get a new one
upload_2021-4-14_14-28-50.png
 

Back
Top