All my parts are in, I'll be upgrading my system to low oxygen brewing, I'll send pictures when it's done. And tested.
Can't wait to brewing again.
Can't wait to brewing again.
...both of which are turning out to be a bitch to obtain here in GermanyBrewtan b isn't obtainable in the US, I just use sodium metabisulfate and Camden tablets, it works great.
Are you worried about DMS trapped during the boil?Here is the layout of the lid that I am engineering to put on my kettles it has three anchors on the Outer Edge the door in the middle is 4 hop and or acid additions there will be a seal between the lid and the kettle so it stops any air Ingress to the system I can then Purge the kettle before I start my Brew session I have not done any of the drilling yet I just wanted to give you a rough idea of what I'm doing
Ok at sea level boiling point is 212FI put 5 pound pressure relief valves on the lids steam will be able to release itself at will without a problem