Strike water Volume

Discussion in 'Recipe Editor' started by nflamedrash, Jul 5, 2015.

  1. nflamedrash

    nflamedrash Member

    Joined:
    Jul 1, 2013
    Messages:
    58
    Likes Received:
    28
    Trophy Points:
    18
    Location:
    Wilmington, Delaware
    When working in a brew session I noticed that when changing the Mash Thickness on the Mash Calculator tab does not update the Water Requirements tab. Not a real problem but I do find myself switching back and forth between the tabs and when they are out of sync it can be confusing.

    If it is never fixed I will still love using the product.

    Cheers.
     
  2. Ozarks Mountain Brew

    Staff Member

    Joined:
    Nov 20, 2012
    Messages:
    7,767
    Likes Received:
    3,976
    Trophy Points:
    113
    Gender:
    Male
    Occupation:
    IT Managment
    Location:
    The Ozark Mountains of Missouri
    is this just creating a recipe or a brew session thats been saved and changed, one thing to remember, you have to put the mash% like 1.25 in the mash section of the recipe editor before the water reads correct

    also if changing a recipe in a brew session you have to update the brew session or rebuild the brew
     

    Attached Files:

  3. Nosybear

    Nosybear Well-Known Member

    Joined:
    Jul 16, 2012
    Messages:
    9,400
    Likes Received:
    6,641
    Trophy Points:
    113
    Location:
    Aurora, CO, USA
    Ran into the same issue. I changed the recipe then rebuilt the brew. Only solution I could find.
     

Share This Page

arrow_white