As of this morning when you go to input Indgredients into a Recipe using the drop down, you don't get all the ingredients listed unless you select all grain. Once this is done you have all the options on the first line. When you go to input next ingredient you don't get all your options again unless you delete second line and add a new line, then you get full list in drop down to choose from. It is a new glitch that I stumbled upon.
Recipe Builder
- Thread starter Bruman
- Start date
- Joined
- Nov 16, 2013
- Messages
- 3,234
- Reaction score
- 2,549
- Points
- 113
- Location
- Upper Michigan/S. Florida
I just tried, and worked the same old way as usual for me. Can you take a screen shot and post it? Or email it to me at mail@brewersfriend.com if you don't want to make it public?
You don't get the grain choices that require mashing though, if you don't select partial mash or all-grain, since the base grains require mashing.
Ah- never mind. I set it up as extract, and then changed it to partial mash, and that's when I couldn't select the grains. If I started as partial mash, then no problem. The extract batches don't show grains. Gotcha!
I didn't know if this was due to your updated apple compatibility or not. Also it starts your recipes out at 35% efficiency which i didn't change because before it was around 70% when you started, but figured out later. It was actually pretty funny because I had put 14lbs of pale malt and it gave me a starting gravity that was really low like 1.013 then I saw efficiency setting. There is a work around for the previous and is not a problem, but I know that it had worked differently before.
It also does if when you initially set to full grain. It will let you input first Ingredient but for next one after that it will not give you all the options. Unless you delete second line and hit add, then gives you all options in drop down.
