Partial Mash Recipe Editor Hop Utilization?

Discussion in 'Recipe Editor' started by wolfie7873, Mar 11, 2015.

  1. wolfie7873

    wolfie7873 Member

    Joined:
    Aug 28, 2013
    Messages:
    111
    Likes Received:
    4
    Trophy Points:
    18
    Location:
    Raleigh, NC
    I'm not sure the hop utilization is correct for partial mash recipes, and i suspect it has something to do with not understanding how to tell the recipe calculator what goes in when. Is there a trick to it?
     
  2. wolfie7873

    wolfie7873 Member

    Joined:
    Aug 28, 2013
    Messages:
    111
    Likes Received:
    4
    Trophy Points:
    18
    Location:
    Raleigh, NC
    I've seen views on this thread, but no replies. I did look through the FAQs (which I had until now assumed were more about how to use the forum rather than how to use the features of the site) and found what I was looking for. If you click the down arrow under the extract addition, you can specify "Late Addition." on the (in my case) LME, that removes those gravity points from the boil for the hop utilization calculation.
     

Share This Page

arrow_white