(ANSWERED) Mash Chemistry and Brewing Water Calculator

[usmnt1099@yahoo.com]

Would it be possible, when using this calculator, to be able to import a grain bill to the Grist info, from an already established recipe, and not need to plug it in manually?

 

[LarryBrewer]

(ANSWERED) Re: Mash Chemistry and Brewing Water Calculator

Yes we already support this going from the Recipe to the Mash Chemistry and Brewing Water Calculator.

Start a recipe, make sure it has a water profile selected in the drop down, then save it. A link to the Mash Chemistry and Brewing Water Calculator will then become active in the Recipe's water section. Following that link will setup the water calculator with the recipe grist, plus the water volume levels based on the water requirements calculation of the recipe (which uses your profile).

 

[usmnt1099@yahoo.com]

Thanks Larry. I will try and not make you point out such obvious things in the future. :roll:

 

[LarryBrewer]

Not a problem. There are many little details built into the system.