Android Weird post-boil gravity

[Brewer #296232]

Recipe ID 1509169

 

[Donoroto]

Recipe ID 1509169

View attachment 30456

I see pre boil volume is 20.97 litrrs, post boil is 5.5 liters. Boiling off 75% of the water can cause that.

Check your boil off rate settings

 

[Brewer #296232]

It's 1lt an hour, you can see it in water requirements etc. Original gravity is also correct. Post-boil gravity on the website is also correct.

 

[Donoroto]

I can’t say why the post-boil volume changed so much.

I also have a Brewzilla and my boil off rate is 5 liters per hour.

Perhaps @Yooper can look into your profile and spot something.

 

[Minbari]

Does the app use the boil-off rate to determine final volume or do you set it?

The app i use will suggest you final volume based on your profile, but you can input what you actually had. This allows top-up water if you boil short

 

[Brewer #296232]

I can’t say why the post-boil volume changed so much.

I also have a Brewzilla and my boil off rate is 5 liters per hour.

Perhaps @Yooper can look into your profile and spot something.

Recipe was created via website. Website doesn't show any weird numbers. Even the Android App shows the right post-boil size in Water Requirements, and right Original Gravity at the top - it's only Stats that are messed up.

Is there a better way to report issues I stumble across in your software, or is this forum a right place? "I am something of a software engineer myself" so I know bug when I see one, and I also know how valuable community reporting can be. I'm also paying money to use your software, would be awesome if I can finally trust it and not re-checking Quick Water Requirements math manually after a few traumatic experiences in the past

P.S. Low boil-off rate is due to using the steam condenser.

 

[Donoroto]

Recipe was created via website. Website doesn't show any weird numbers. Even the Android App shows the right post-boil size in Water Requirements, and right Original Gravity at the top - it's only Stats that are messed up.

Is there a better way to report issues I stumble across in your software, or is this forum a right place? "I am something of a software engineer myself" so I know bug when I see one, and I also know how valuable community reporting can be. I'm also paying money to use your software, would be awesome if I can finally trust it and not re-checking Quick Water Requirements math manually after a few traumatic experiences in the past

P.S. Low boil-off rate is due to using the steam condenser.

Ok on the boil rate.

This is technically the correct channel to report bugs.