Settings for Blichmann BrewEasy? (10gal/240V)

Discussion in 'General Brewing Discussions' started by MrEggSandwich, May 15, 2016.

  1. MrEggSandwich

    MrEggSandwich New Member

    Joined:
    Aug 20, 2012
    Messages:
    13
    Likes Received:
    3
    Trophy Points:
    3
    Location:
    Hunterdon County, NJ
    Hello there!

    Anyone here have experience with settings within Brewer's Friend? BIAB profile? Boil off? etc..

    Any help is appreciated.
     
  2. Ozarks Mountain Brew

    Staff Member

    Joined:
    Nov 20, 2012
    Messages:
    7,501
    Likes Received:
    3,392
    Trophy Points:
    113
    Gender:
    Male
    Occupation:
    IT Managment
    Location:
    The Ozark Mountains of Missouri
    if no one answers with the correct settings it shouldn't be any different than any 10 gallon set up, just fill out your settings with the correct pot size then after a few batches figure out how much you lose for your loses, add that to your profile then try a recipe with 70% efficiency and go from there. if your low change it and high vise versa
     
  3. bilhelm96

    bilhelm96 Member

    Joined:
    Aug 12, 2012
    Messages:
    91
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    NJ, USA
    I have a pseudo Brew Easy setup with a 10g Boilermaker as the mash tun and a 15g with 240V coil for the boil kettle. I use the "All Grain" method in my recipes and get about 60-70% ending kettle efficiency depending on the amount of grain. I boil off at a rate of 1.5 gallons per hour.
     

Share This Page

arrow_white