Cross-threaded keg post

[wildmancurry]

I cross threaded the out post on a keg, on the keg not the nipple (ha ha, nipple. I think that is the correct term though) Is there anything i can do to fix this problem or have a created a stainless steel carboy?

 

[Mase]

If you have a tap and die set, you might be able to rethread it. But stainless steel can be tricky. Oh.... the word you were looking for is “post”. Lol

 

[716Brewer]

If you try rethreading yourself use anti-seize on the die or galling may occur and both the keg and the die will be useless.

 

[GFHomebrew]

Good luck with your twisted nipple curry. Hope you can make heads or tails of it.

 

[Mase]

... just don’t tell your wife you are running to the “Nipple” Office to send out a letter.